RECO

Buffer Tanks

Our buffer tanks add heating or cooling capacity to non-potable, closed-loop systems where the peak demand would otherwise exceed the ability of the system to satisfy it. They are found with low-mass boilers, geothermal systems, and large-scale environmental control systems.

Specifications & Ratings

Materials
ASTM SA-516-70 carbon steel tanks as standard
Specifications
Designed to ASME B & PV Code, Section VIII, Division I
Ratings
150 PSIG max design pressure, 250°F max design temperature
Connections
All connections over 2½” are ANSI 150 lb. RFSO flanges
Exteriors
Sandblasted per SSPC-SP 6 and coated with a red oxide primer
Orientation
Vertically mounted with a ring base or (4) support legs, Horizontally mounted with two support saddles

Buffer Tanks

The RECO buffer tanks are designed for storage capacities up to 2,000 gallons as standard and are available with storage capabilities up to 30,000 for custom orders. All buffer tanks are provided with an internal inlet deflector (CW) or flow partition (HW) and are available with a fully insulated and jacketed exterior. Installed in a system, the reco buffer tank reduces cycling, improves temperature control, and helps provide for a more even response to system demand.

Key Features and Benefits

  • As a chilled water buffer tank in an air conditioning or refrigeration system these tanks help satisfy demand when cooling loads are low by drawing from the chilled water they hold. This avoids the need for a full system start, which reduces equipment wear and overall energy consumption.
  • As a hot water buffer tank these tanks provide both thermal mass and thermal storage to a system. The thermal mass helps stabilize the water temperature while the thermal storage provides capacity during periods of low demand. This reduces the number of boiler starts and need for full system operation.
  • Welded carbon steel vessel designed and built‐in strict accordance with the ASME Code Section VIII and stamped, certified, and registered with the National Board of Boiler and Pressure Vessel Inspectors
  • Designed for 125 psig max design pressure, higher design pressures up to 300 psig are available. 
  • Internal baffle depending on design. 
  • Ring base support and two lift lugs are standard. 
  • Red oxide primer exterior finish. 
  • Inspections opening provided according to ASME code.  Standard one (1) year tank warranty.  Optional extended

Featured Products

Custom Fabrication for Your Specific Needs

Get More Information About RECO Buffer Tanks